About the Script Inspector
A general Script Inspector appears when no command lines in the script are selected. To
display the script’s Script Inspector, you need to either click in an empty area below the
command lines in the Script Editor or click the script’s name in the Outline or Graphical
tab.
Configure the
GPRM partitions.
Enter a name for
the script.
Use these to
import and export
GPRM configurations.
484
Chapter 20
Creating Scripts
The Script Inspector displays values showing the number of commands used and how
many are still available out of the possible total of 124. (Configuring a scripting command
may use up to 16 of the 124 commands.) These values will turn red if your script uses
more than 124 commands, with a negative number in the Commands Remaining value
indicating how many excess commands there are.
It is also where you name your script and then configure the partitions and names of the
GPRM registers.
Note: You can also configure the partitions and names of the GPRM registers in the
Advanced tab in the Disc Inspector.
See
Configuring GPRM Partitions
for more information.